Soudal Soudafix P300-ST Resin Polyester Based Chemical Anchor – 300ml – Dark Grey – 124954

Soudal Soudafix P300-ST can be used in a standard high quality sealant gun.

Soudafix P300-ST Styrene polyester resin based chemical anchor that’s ideal for anchoring of threaded rods and chemical anchors in solid uncracked concrete and other masonry.

Styrene chemical anchor suitable for internal with ventilation and external use.

Suitable for M8 to M16 fixings and threaded bar.

Benefits

• Easy mix twin bag system
• 300ml can be applied using a standard strong sealant gun
• Securing of heavy loads in solid and hollow building materials
• Rapid curing system
• Super strong
• High chemical resistance
• High water resistance
• Pressure free anchoring even close to edges

Areas For Use

• Fixing wall ties
• Bolts and screws into a wide range of building substrates
• Securing machinery into floors
• Fixing studs and fixings
• Threaded bar and chemical anchor fixings
• Can also be used as a repair mortar

How to use P300-ST

Solid

1. Drill hole at recommended depth
2. Clean the hole with a air pump then with a brush and again with air thoroughly.
3. Screw static mixer onto cartridge and dispense the first 10cm of the product to waste until an even colour dark grey is achieved with no light streaks.
4. Dispense the chemical anchor into the hole from the bottom with the long nozzle working upwards, there needs to be enough product in the hole that the chemical anchor spills over when the rod or anchor is pushed into the mix using a slight backwards and forwards screwing motion, this ensures that no water will sit in the hole and damaging the fixing over time.

Hollow Brick or block

1. Drill hole at recommended depth
2. Clean the hole with a air pump then with a brush and again with air thoroughly.
3. Screw static mixer onto cartridge and dispense the first 10cm of the product to waste until an even colour dark grey is achieved with no light streaks.
4. Insert the sleeve dispense the chemical anchor insert and fill it bottom up so that the resin is pressed through the tiny holes of the sleeve with the long nozzle working upwards, there needs to be enough product in the hole that the chemical anchor spills over when the rod or anchor is pushed into the mix using a slight backwards and forwards screwing motion, this ensures that no water will sit in the hole and damaging the fixing over time.

Don’t move the anchor during curing

Once fully cured install component, applying the right torque

Installation parameters can be found int the technical data sheet

Refer to technical data sheet for instructions prior to commencing work.